SPS - smart production solutions 2024

Our KDS-SR90 cable entry system ensures fast and safe 90-degree entry of cables and conduits with IP66 protection. The innovative angled screw frame offers protection against dust and deposits and can be easily fitted with pre-assembled or unassembled cables and conduits. The frames can be fitted with the tried-and-tested basic components (inlays and sealing elements) of the CONTA-CLIP cable management system for sealing. They are mounted using M5 screws. This makes cable management on enclosures and housings child's play and changes can be made at any time without tools - quickly, safely and in just a few steps.

The 2-component combination sealing elements consisting of an elastic seal and robust strain relief enable flexible cable entry for prefabricated and non-prefabricated cables with protection class IP66. The two-part sealing element, whose half-shells can be easily opened and closed with a snap lock, guarantees the installation-friendly and precisely fitting sheathing of the cables. For installation, the combi sealing elements are pressed into the openings of the previously attached inlays of the KDS cable entry systems from the inside to the outside.

The special design of the sealing elements enables compliance with the specified tensile forces for retention capacity and strain relief for non-armoured cables and conductors in version A of the DIN EN 62444:2014-05 standard (cable glands for electrical installations) 

Due to their enlarged sealing range, they currently cover cable diameters from 1 mm to 9 mm and therefore simplify storage requirements.

With the KES-E-R cable entry system, many cables with different diameters from 1.0 mm to 22.5 mm can be inserted in the tightest of spaces. The cable entry system with its striking dodecagonal design is inserted into the intended opening without tools. To insert the cables, the corresponding membrane is pierced with a screwdriver and the cables are simply installed through it. The TPE material ensures tightness.

Save valuable installation time with the KES-R M cable entry system. Many cables with different diameters from 1.5 mm to 22.2 mm can be inserted in the tightest of spaces. The cable entries are snapped directly from the outside into a round standardised cut-out (hole dimensions: M25 to M63) without tools. For greater wall thicknesses and to achieve a higher degree of tightness (up to protection class IP66), the entries can also be screwed together with a locknut. Fitting takes place in a matter of seconds. Simply pierce the sealing membrane with a screwdriver at the marked point and insert electrical and pneumatic cables. The material mix (membrane) TPE and core (PA 6.6 glass fibre reinforced) ensures tightness and stability.